12/26/2023 0 Comments Digital audio out to rca best buy![]() ![]() ![]() A ground loop is when grounds on the different equipments are connected so that a loop is created. RCA on analog is good, but it might have trouble with induced noise. If you have higher quality source, it might depend. The main reason is that they seldom tell the full story when it comes to specifications so you need to try. With consumer or prosumer equipment it is difficult to tell. * and of course, 'good quality' does not necessarily mean 'expensive'. In some cases it might be better to run an analogue connection from an excellent DAC to an amplifier, than to go to a digital in on the amplifier IF the amplifier has a so-so DAC (and if it isn't going to convert your analogue signal to digital internally anyway). If you're near the end of your signal chain and you're wondering at what point you should finally go out to analogue - that will depend on the quality of your DACs and your cabling*. (I'm assuming here that the digital connection is working within its design tolerances and is transferring the digital values 100% accurately, which should be the case most of the time - though it is possible to have issues with deficient cables, incompatible clocking, etc.) There's generally nothing to be gained from converting to analogue and back to digital again most likely, you'll only lose quality that way. ![]() If your receiving device is going to convert the sound to digital again internally, then you should connect TO it digitally if you have the option. Is there a clear and general "best" option for connecting the devices, is it basically the same either way, or does the answer depend entirely upon the specific devices being used?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |